Silex Technology PRICOM C-6400W Manuel D’Utilisation

6-2

Q&A

 Example) Execute the ping on MS-DOS of Windows 98

 To execute the 

 command click 

 - 

 - 

, then enter the ping command (XXX.XXX.XXX.XXX is IP address for the PRICOM).

   

Reply from XXX.XXX.XXX.XXX:bytes=32 time=58ms TTL=253

Reply from XXX.XXX.XXX.XXX:bytes=32 time=58ms TTL=253

Reply from XXX.XXX.XXX.XXX:bytes=32 time=58ms TTL=253

          Reply from XXX.XXX.XXX.XXX:bytes=32 time=58ms TTL=253

   

Request timed out.

Request timed out.

Request timed out.

Request timed out.

2.

Try to login using telnet. If you cannot login to the PRICOM C-6400W, you may not

have assigned the IP address correctly. Verify the desired IP address for the PRICOM

C-6400W and change the configuration.

3.

If the PC and the PRICOM C-6400W are not on the same segment, you should configure

the subnet mask and gateway address in the PRICOM C-6400W. This can be done

using the PRICOM User Software CX2.

4.

Make sure that the printer port name of the PRICOM C-6400W is displayed behind

.

I cannot print

1.

Make sure the Link LED of the PRICOM C-6400W is on. If not, verify the following

settings.

 - Does the PRICOM C-6400W turn on?

 - Is the USB cable connected correctly?

 - Are the SSID, Channel and WEP key correct ?

 - Are the network cables for your PC and access point connected correctly?

 - Are network cables for your PC and access point damaged ?

 - Are the Link LED's for your PC and access point lighting ?

 - Is the Ethernet HUB working correctly?

 - If you can use the TCP/IP protocol, use the ping command to verify the proper response

from the IP address assigned to the PRICOM C-6400W. If the PRICOM C-6400W does

not respond, it is possible the IP address is incorrect. Restore factory defaults in the

PRICOM C-6400W and configure the IP address again.