Epson PP-100 Manuel D’Utilisation

❏ If you use an extension cord with the product, make sure that the total ampere rating of 

the devices plugged into the extension cord does not exceed the cord’s ampere rating. 
Also, make sure that the total ampere rating of all devices plugged into the wall outlet 
does not exceed the wall outlet’s ampere rating.

❏ Do not attempt to service the product yourself.

❏ Unplug the product and refer servicing to qualified service personnel under the 

following conditions:
The power cord or plug is damaged; liquid has entered the product; the product has 
been dropped or the casing is damaged; the product does not operate normally or 
exhibits a distinct change in performance.

❏ If you plan to use the product in Germany, the building installation must be protected by 

a 10 or 16 amp circuit breaker to provide adequate short-circuit protection and 
over-current protection for the product.

❏ When connecting the product to a computer or other device with a cable, ensure the 

correct orientation of the connectors. Each connector has only one correct orientation. 
Inserting a connector in the wrong orientation may damage both devices connected by 
the cable.

❏ If damage occurs to the plug, replace the cord set or consult a qualified electrician. If 

there are fuses in the plug, make sure you replace them with fuses of the correct size 
and rating.

❏ Commercially available replacement drives do not function on this product.

Observe the following when choosing a place for the product:

❏ Place the product on a flat, stable surface that extends beyond the base of the product 

in all directions. If you place the product by the wall, leave more than 10 cm (3.94") 
between the back of the product and the wall. The product will not operate properly if it 
is tilted at an angle.

❏ When storing or transporting the product, do not tilt it, stand it on its side, or turn it 

upside down. Otherwise, ink may leak from the cartridges.

❏ Leave enough space in front of the product for the disc cover to be fully opened.

❏ Avoid places subject to rapid changes in temperature and humidity. Also, keep the 

product away from direct sunlight, strong light, or heat sources.

❏ Avoid places subject to dust, shocks, or vibrations.