FARGO electronic 410 Manuel D’Utilisation
RESTRICTED USE ONLY
Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 5.0)
28
Powering up the Card Printer
The power supply within the Printer is a universal power supply properly configured for the
power used in the (respective) country. To connect power to the Printer, locate the
appropriate power cord for the country and refer to the following steps:
power used in the (respective) country. To connect power to the Printer, locate the
appropriate power cord for the country and refer to the following steps:
Step Procedure
1
CAUTION! The (included) two (2) power cords are designed for use
only with the Card Printer. (Note: If you have any doubts about the plug
configuration or the voltage, do not attempt to use the Printer. Contact the Fargo
authorized reseller for information on the correct power configuration.)
configuration or the voltage, do not attempt to use the Printer. Contact the Fargo
authorized reseller for information on the correct power configuration.)
Locate the power cord included with the Card Printer.
2
Place the power cord into the power cord port of the Card Printer.
3
Place the AC power plug end of the power supply cord into an available wall
outlet.
outlet.
4
Press the Power button if you wish to turn the Printer ON or OFF. (Note: If the
Printer will not be used for a long period of time, unplug the power cable to the
Card Printer to ensure that all power is disconnected from the unit.)
Printer will not be used for a long period of time, unplug the power cable to the
Card Printer to ensure that all power is disconnected from the unit.)