Primera Technology LX200 Manuel D’Utilisation

E. ADJUSTING THE LABEL STOCK TOF (TOP OF FORM) 

SENSOR

If you are using label stock other than standard square / 

rectangular die cut labels such as circular die-cut labels or

through-hole stock use the instructions below to adjust the

label stock TOF sensor.

Circular Labels
If you are using Circular Labels you must adjust the Stock 

sensor to correspond with the very top of the label where the

circles are closest together. If the sensor is too far to the right or

the left the printer will still sense the label but the image may

be offset downward because the printer will start printing at

the wrong position. If you are using stock that has multiple

labels across make sure the sensor corresponds to a place on

the stock that has a label and not a vertical gap.

0.5

1.0

1.5

2.0

12.7

25.4

38.1

50.8

mm

 in.

Label Stock Sensor Bar

511203.qxd  8/7/2008  2:21 PM  Page 9

TOC

INDEX