Epson EB-G6550WU Manuel D’Utilisation

Status

Cause

Remedy or Status

High Temp Warning

(This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.

s

s

 "Replacing  the  Air  Filter"  

Replace Lamp

Replace it with a new lamp.

s

If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may explode increases. Replace it with a
new lamp as soon as possible.

Low Air Flow

Check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.

s

s

 "Replacing  the  Air  Filter"  

If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.

s

Air Filter Notice

"Time to clean the air filter. Clean or replace the air filter."is displayed. Clean the air filter.

s

The indicators or messages regarding Air Filter Notice are displayed only when Air Filter Notice is set to On from the Configuration menu.

s

 Extended - Display - Air Filter Notice

a

• See   the   following   if   the   projector   is   not   operating   properly,  even  though  the  indicators  are  all  showing  normal.

s

• If the indicators are in a state not shown in this table, stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or

the  nearest  address  provided  in  the  Epson  Projector  Contact  List.

s