Epson EB-1776W/EB-1771W/ EB-1761W/EB-1751 Manuel D’Utilisation

Check

Remedy

Is the correct port selected?

Change the image by pressing the [Source Search] button on the remote control or the control panel.

s

Is the power for the computer or video source turned on?

Turn the power on for the equipment.

Are the image signals being output to the projector?
(Only when projecting images from a laptop computer or a
computer with a built-in LCD screen)

If the image signals are only being output to the computer's LCD monitor or to the accessory monitor, you need to
change the output to an external destination as well as the computer's own monitor. For some computer models, when
the image signals are output externally, they no longer appear on the LCD monitor or accessory monitor.
If the connection is made while the power of the projector or computer is already turned on, the Fn key (Function key)
that changes the computer's image signal to external output may not work. Turn the power for the computer and the
projector off and then back on again.

s

s

 Computer's documentation

Check

Remedy

Is the distance between the projector and the screen over 2.5 m? (For
EB-1776W)

For the projected image to be automatically adjusted by Auto H/V-Keystone or Screen Fit, the projector should be
approximately 1.0 to 2.5 m away from the screen. If the projector must be placed further away than this, manually adjust
the projected image.

Is Auto H/V-Keystone set to Off? (EB-1776W only)

Setting it to On enables Auto H/V-Keystone.

s

 Settings - Keystone - Auto H/V-Keystone 

If you are using the projector with this setting off, manually adjust the projected image.

s

Is the focus adjusted correctly?

Adjust the focus using the [Focus] buttons (EB-1776W only) or Focus ring (EB-1771W/EB-1761W/EB-1751 only).

s

Is the projector at the correct distance?

Is it projecting outside of the recommended projection distance range?
Setup within the recommended range.

s

Is the keystone adjustment value too large?

Lower the projection angle to reduce the amount of keystone correction.

s