Peerless Industries HDS200 Manuel D’Utilisation
23 of 36
ISSUED: 07-24-12 SHEET #: 180-9023-1
Notes:
1.
Audio and video sources will switch simultaneously whether using the remote or Power/Source
Selection Button.
Selection Button.
2.
Independent audio switching is only allowed for AV and PC audio.
3.
Inputs on the Transmitter and Receiver can be switched by pointing the remote at the Transmitter or
Receiver ONLY if the connection between Transmitter and Receiver has been established, Link Indicator
Light on.
If the connection between Transmitter and Receiver has not been established, the inputs need to be
selected at the location of each unit using either of the above input and output selection methods.
Receiver ONLY if the connection between Transmitter and Receiver has been established, Link Indicator
Light on.
If the connection between Transmitter and Receiver has not been established, the inputs need to be
selected at the location of each unit using either of the above input and output selection methods.
Peer-to-Peer and Multicast LAN (wired) Mode Installation
Peer-to-Peer Direct LAN Connection
Step 1
Connect the LAN cable between the RJ45 jack
on the Transmitter and Receiver. The green light
at the connector will turn on solid.
on the Transmitter and Receiver. The green light
at the connector will turn on solid.
Step 2
With the system running (Power/Link Indicator
Light solid and input and output Indicator Lights
solid), point the remote at the Receiver, press and hold the LAN button for 5 seconds
until all the indicator lights start fl ashing on both the Transmitter and the Receiver.
Light solid and input and output Indicator Lights
solid), point the remote at the Receiver, press and hold the LAN button for 5 seconds
until all the indicator lights start fl ashing on both the Transmitter and the Receiver.
Note:
The video and audio will be lost during this process.
Step 3
Allow the HD Flow Pro Wireless Multimedia Kit to re-start. Do not remove power, reset, or use the remote while
the system is restarting. Restart of the HD Flow Pro Wireless Multimedia Kit may take up to 2 minutes.
the system is restarting. Restart of the HD Flow Pro Wireless Multimedia Kit may take up to 2 minutes.
Step 4
Once the HD Flow Pro Wireless Multimedia Kit has restarted, check the LAN connection indicator light on the
back of the unit. The indicator lights on both the Transmitter and Receiver should be blinking rapidly. The WiFi
indicator lights on the front of both the Transmitter and the Receiver will be solid.
back of the unit. The indicator lights on both the Transmitter and Receiver should be blinking rapidly. The WiFi
indicator lights on the front of both the Transmitter and the Receiver will be solid.
LAN Connection Through Router
Selecting Input and Output Port
There are two ways to select input and output sources on the HD Flow Transmitter and Receiver:
1. Using the provided Remote
•
Transmitter - Press the desired input while pointing the remote at the Transmitter unit.
•
Receiver - Press the desired output while pointing the remote at the Receiver.
2. Using the Power/Source Selection Button
•
Transmitter / Receiver - To toggle between inputs press the Power/Source Selection Button on the unit
itself.
itself.
Peer-To-Peer
Direct Lan
Connection
Direct Lan
Connection