Manualsbrain.com
  1. Manuels
  2. Marques
  3. RAD Data comm
  4. Modular Access Device with Integrated Router
  5. Manuel D’Utilisation

RAD Data comm Modular Access Device with Integrated Router Manuel D’Utilisation

Télécharger
Page de 224
FCD-IPM Installation and Operation Manual 
Chapter 5  Setup Menu 
 
Interface Parameters Menu 
5-59 
On/off hook from the E1 on 
Select this parameter to specify the receive mode for on/off hook signaling from E1 
into FXS. The values are: 
A bit 
When the received A bit signal from E1 equals 1 then off hook will be 
indicated in the FXS interface 
When the received A bit signal from E1 equals 0 then on hook will be 
indicated in the FXS interface 
A bit inverted 
When the received A bit signal from E1 equals 1 then on hook will be 
indicated in the FXS interface 
When the received A bit signal from E1 equals 0 then off hook will be 
indicated in the FXS interface 
B bit 
When the received B bit signal from E1 equals 1 then off hook will be 
indicated in the FXS interface 
When the received B bit signal from E1 equals 0 then on hook will be 
indicated in the FXS interface 
B bit inverted 
When the received B bit signal from E1 equals 1 then on hook will be 
indicated in the FXS interface 
When the received B bit signal from E1 equals 0 then off hook will be 
indicated in the FXS interface 
On/off hook to the E1 on 
Select this parameter to specify the transmission mode for on/off hook signaling 
from FXS to E1. The values are: 
A bit 
For off hook indicated in the FXS interface, the transmitted A bit signal will 
be set to 1 towards E1 
For on hook indicated in the FXS interface, the transmitted A bit signal will 
be set to 0 towards E1 
A bit inverted 
For off hook indicated in the FXS interface, the transmitted A bit signal will 
be set to 0 towards E1 
For on hook indicated in the FXS interface, the transmitted A bit signal will 
be set to 1 towards E1 
B bit 
For off hook indicated in the FXS interface, the transmitted B bit signal will 
be set to 1 towards E1 
For on hook indicated in the FXS interface, the transmitted B bit signal will 
be set to 0 towards E1 
B bit inverted 
For off hook indicated in the FXS interface, the transmitted B bit signal will 
be set to 0 towards E1 
For on hook indicated in the FXS interface, the transmitted B bit signal will 
be set to 1 towards E1. 
Default ABCD to the E1 
Select this parameter to specify signaling bits that are not in use for the on/off hook 
or for the polarity (if enabled). Those bits will be transmitted towards E1.