Cisco Systems 1240AG Manuel D’Utilisation

Follow these steps to issue the Cisco IOS command for your power scenario:

Connect a PC to the access point console port and use a terminal emulator to establish a session with the 
access point (refer to the 

).

From the global configuration mode (refer to the Cisco IOS Software Configuration Guide for Cisco 
Aironet Access Points), enter the command below that applies to your power configuration (see 

):

no power inline negotiation prestandard source

Enter the write memory command to save the setting to the access point memory.

Enter the quit command to exit the terminal session.

AC power module

None required

Cisco switch that supports Intelligent Power 
Management

1

1.

You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support 
for Intelligent Power Management might not be currently available for your Cisco power source.

Cisco switch that does not support Intelligent 
Power Management

1

Power injector

2

 used with a Cisco switch that 

supports Intelligent Power Management

1

2.

Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.

None required

3

3.

The Cisco switch uses Intelligent Power Management to inform the access point of the power injector being used.

4

4.

Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.

Power injector

2 

used with a Cisco switch that 

does not support Intelligent Power 
Management

1

power inline negotiation injector installed 

Power injector used with a non-Cisco switch

None required

– 

802.3af compliant non-Cisco switches

None required

–