CNet Technology CNIG904S Manuel D’Utilisation
CNet Technology Inc
4
Physical Details
Please take a few minutes to familiarize yourself with the Broadband Router.
Top - Mounted LEDs
There are 2 LEDs on the top of the unit. The "DATA STATUS LAN" LED has 2 colors -
Green and Orange. Operation of these LEDs is as follows:
Green and Orange. Operation of these LEDs is as follows:
DATA STATUS LAN
(Green/Orange)
(Green/Orange)
On (Green) - Normal start up/power on sequence, or idle.
The Data/Status LED will flash under the following conditions:
• Flashing (Green) – The Data/Status LED will flash when
• Flashing (Green) – The Data/Status LED will flash when
data is transmitted or received through the LAN ports.
• Flashing (Orange, Green, Orange,…) – Hardware error.
Contact your dealer for technical support.
DATA WAN
(Green)
(Green)
On - Normal start up (power ON) sequence or idle.
Flashing – The Data LED will flash when data is transmitted or
received through the WAN port.
received through the WAN port.
Rear Panel
Reset
button
button
10/100 BaseT
LAN Connectors
LAN Connectors
Power
Input
WAN
Uplink
RESET
WAN
port
port
DIP
switches
LAN Port
LEDS
LEDS
4
3
2
1
WAN port
LED
LED
1 2 3
4
Link/
Act
100
LAN
Uplink
port
port
Figure 2: Rear Panel
DIP switches
Refer to the following table for DIP switch operation.
LAN Port LEDs
- Link/Act
- Link/Act
On - The Router is successfully connected to a device through the
corresponding port (1, 2, 3, or 4).
corresponding port (1, 2, 3, or 4).
Flashing - Transmitting or receiving data over that port.
LAN Port LEDs
- 100
- 100
On - LAN port connection is using a 100BaseT connection.
Off - Port is unused or using 10BaseT connection.
10/100BaseT
LAN Connectors
LAN Connectors
Use standard LAN cables (RJ45 connectors) to connect your PCs ot
these ports. Both 10BaseT and 100BaseT connections can be used
simultaneously.
these ports. Both 10BaseT and 100BaseT connections can be used
simultaneously.
If Port 4 is used, the "Uplink" port can NOT be used..
Uplink Port
Use the "Uplink" port ONLY to connect (via a normal LAN cable)
to a normal port on another hub.
to a normal port on another hub.
If the "Uplink" port is used, Port 4 can NOT be used.