ZyXEL Communications omni.net LCD+M Manuel D’Utilisation
Technical Reference for ZyXEL omni.net series
4-6
Manually Switching Communication Mode (for ZyXEL omni.net
LCD/LCD+M/Plus)
LCD/LCD+M/Plus)
The manual switching functions will only be necessary if your communication software does not
allow you to change your dial-up string.
Conventional dialing commands [ATD], [ATDT] and [ATDP], used by much existing
communication software, can be mapped onto one of the new dialing commands according to the
[AT&O] setting, as follows:
communication software, can be mapped onto one of the new dialing commands according to the
[AT&O] setting, as follows:
For ZyXEL omni.net LCD/Plus:
Manual Switch AT Command
Dial string it will map to
AT&O0
ATD, ATDT, ATDP are the same as [ATDB]
AT&O2
ATD, ATDT, ATDP are the same as [ATDI]
AT&O3
ATD, ATDT, ATDP are the same as [ATDA]
Table 22. Manual Switch AT Command For ZyXEL omni.net LCD/Plus
For ZyXEL omni.net LCD+M:
Manual Switch AT Command
Dial string it will map to
AT&O0
ATD, ATDT and ATDP are the same as ATDM
AT&O1
Auto-selection of 64kbps and 3.1 kHz on outgoing
calls
calls
AT&O2
ATD, ATDT and ATDP are the same as ATDI
AT&O3
ATD, ATDT and ATDP are the same as ATDA
Table 23. Manual Switch AT Command For ZyXEL omni.net LCD+M
(For more information on ZyXEL omni.net LCD+M, please refer to Chapter 9 Internal
Fax/Modem Function)
Fax/Modem Function)
The factory default setting is [AT&O2] that instructs the omni.net to select ISDN data mode when
you do not otherwise specify which communication mode to use (i.e. ATD or ATDT).
you do not otherwise specify which communication mode to use (i.e. ATD or ATDT).