RAD Data comm IPmux-11 Manuel D’Utilisation
Installation and Operation Manual
Chapter 2 Installation and Setup
IPmux-11 Ver. 2.00
Connecting IPmux-11 to Power
2-5
Before connecting or disconnecting any cable, the protective earth terminals of
this unit must be connected to the protective ground conductor of the mains
(AC or DC) power cord. If you are using an extension cord (power cable) make
sure it is grounded as well.
Any interruption of the protective (grounding) conductor (inside or outside the
instrument) or disconnecting of the protective earth terminal can make this
unit dangerous. Intentional interruption is prohibited.
this unit must be connected to the protective ground conductor of the mains
(AC or DC) power cord. If you are using an extension cord (power cable) make
sure it is grounded as well.
Any interruption of the protective (grounding) conductor (inside or outside the
instrument) or disconnecting of the protective earth terminal can make this
unit dangerous. Intentional interruption is prohibited.
Connecting AC Power
AC power is supplied to IPmux-11 via a 1.5m (5 ft) standard power cable
terminated by a standard 3-prong socket. A cable is provided with the unit.
terminated by a standard 3-prong socket. A cable is provided with the unit.
To connect AC power:
1. Connect the power cable to the power connector on the IPmux-11 rear panel.
2. Connect the power cable to the mains outlet.
1. Connect the power cable to the power connector on the IPmux-11 rear panel.
2. Connect the power cable to the mains outlet.
The unit turns on automatically upon connection to the mains.
Connecting DC Power
A special IEC 60320 adapter for the -40/-60 VDC power connection is supplied
with the unit.
with the unit.
To connect DC power:
• Refer to the DC power supply connection supplement for instructions how to
• Refer to the DC power supply connection supplement for instructions how to
wire the DC adapters, and to the
section.
Warning