Western Telematic MPC-20VD16-3 Manuel D’Utilisation

Disconnect Power

If any of the following events are noted, immediately disconnect the unit from the outlet 
and contact qualified service personnel:

1.  If the power cord becomes frayed or damaged.

2.  If liquid has been spilled into the device or if the device has been exposed to rain 

or water.

Two Power Supply Cables

Note that some MPC series units feature two separate power circuits, and a separate 
power supply cable for each power circuit.  If your MPC unit includes two power supply 
cables, make certain to disconnect both power supply cables from their power source 
before attempting to service or remove the unit.

Detached 15-Amp “Starter” Cable(s)

If the MPC unit includes a detached, 125 VAC, 15 Amp “Starter” Cable(s,) this allows 
you to connect the MPC to power for bench testing and initial start up is adequate for 
applications that only require 15 Amps.  For 20-Amp power switching applications, 
please refer to the WTI Power Cable guide supplied with the unit, or use appropriate 20-
Amp cables.

Units with Attached Power Supply Cable(s)

For MPC units that include attached power supply cable(s), the socket outlet(s) shall be 
installed near the equipment and shall be accessible.