TANDBERG MSE 8510 Manuel D’Utilisation
66
configured endpoint.
Note that if the original call to the conference was
from the endpoint rather than the endpoint being
invited by the MCU, then for the MCU to
recognize it, that endpoint must be configured
with Call-in match parameters. If the ** ERROR **
did not recognize that the call was from a pre-
configured endpoint then the re-connect control
will not be available.
from the endpoint rather than the endpoint being
invited by the MCU, then for the MCU to
recognize it, that endpoint must be configured
with Call-in match parameters. If the ** ERROR **
did not recognize that the call was from a pre-
configured endpoint then the re-connect control
will not be available.
For more information about configuring
endpoints on the MCU refer to
endpoints on the MCU refer to
and
Displays the time at which a participant
disconnected from the conference and who
initiated the disconnect.
disconnected from the conference and who
initiated the disconnect.
Refer to the table below to get details about pre-configured endpoints.
Indicates whether the participant is an H.323,
SIP, or VNC endpoint.
SIP, or VNC endpoint.
Displays the name of the endpoint.
Displays the connection status of the pre-
configured participant.
configured participant.
This field shows which participants have
connected, which have disconnected, and reasons
for failure if a participant has failed to connect to
the conference.
connected, which have disconnected, and reasons
for failure if a participant has failed to connect to
the conference.
You may wish to inform participants about conference details such as start time, and so on. Click the
icon to display further details about a conference. This information may be copied to the clipboard for
convenience.
Click this icon to watch the conference. This is exactly the same as clicking the
link in the Conference list.