Freescale Semiconductor Microcontrollers Manuel D’Utilisation
Microcontroller Debugging First Steps
Switching Connections
246
Microcontrollers Debugger Manual
17. In the IDE main window toolbar Project menu, choose Project > Make.
18. Now choose Project > Debug to start the debugger.
Figure 10.7 Your Project in Debugger Main Window
Switching Connections
It is possible to switch connections from within an existing debugging project. To switch
connections, select Set Connection from the Component menu. The following information
provides three examples of switching a connection.
connections, select Set Connection from the Component menu. The following information
provides three examples of switching a connection.
CAUTION
Normally, use the New Project or Change wizard to change the
connections. This information is provided for advanced users only.
connections. This information is provided for advanced users only.
Loading the Full Chip Simulation
Connection
Connection
Because there is no actual hardware involved in switching from another project, such as
the SofTec in-Dart HCS08 connection, to the FCS connection, the process is simple. To
load the FCS connection from within an existing project, take the following steps:
the SofTec in-Dart HCS08 connection, to the FCS connection, the process is simple. To
load the FCS connection from within an existing project, take the following steps: