Freescale Semiconductor Microcontrollers Manuel D’Utilisation

497

Microcontrollers Debugger Manual

This chapter guides you through the first steps toward debugging with the CodeWarrior 
IDE and the SofTec HCS08 connection. It does not replace all the additional 
documentation provided in this manual, but gives you a good starting point.

The 8/16 bit debugger (and then the CodeWarrior IDE) can be connected to HCS08 
hardware using the SofTec HCS08.

When the debugger runs the SofTec HCS08 connection, it can communicate and debug 
HCS08 core-based hardware connected through the SofTec in-circuit debugger/
programmer units, that is:

SofTec Microsystems HCS08 ISP Debuggers/Programmers (inDART Series) and Starter 
Kits (PK and newer Series).

Refer to the inDART®-HCS08 In-Circuit Debugger/Programmer for Motorola HCS08 
Family FLASH Devices User’s Manual from SofTec for communication hardware 
requirements and SofTec product installation.

There are two separate paths that may be followed to take the first steps toward debugging 
with the CodeWarrior IDE and the SofTec inDART-HCS08 connection. The differences 
between the two paths hinge on the starting point for the steps:

• Using the Stationary Wizard at the start of the project

• From within an existing project