Tyan Computer B2094T15 Manuel D’Utilisation
32
http://www.TYAN.com
COM Port Addre ss if enabled, will use a port on the system board.
Baud Rate enables the specified baud rate.
Console Type enables the specified console type.
Flow Control enables Flow Control.
Console Connection indicates whether the console is connected directly to the system or
uses a modem to connect.
uses a modem to connect.
Continue C.R. After POST enables Console Redirection after operating system has loaded.
Security Menu
The Security menu contains the security settings that protect your system against unauthorized
use.
use.
Supervisor/U ser Password indicates if a Supervisor or User password exists.
Set Supervisor/User Password sets the Supervisor/User password. The Supervisor can access
the Setup program and boot the system while the User can only boot the system. Passwords are
not case sensitive.
the Setup program and boot the system while the User can only boot the system. Passwords are
not case sensitive.
Diskette Access sets the accessibility of the floppy disk drive.
Fixed Disk Boot Sector protect the boot sector against any changed.
CAUTION: Set this item to disabled before installing an operating system, running
Fdisk
Fdisk
or Format program, or when re-installing software. Otherwise, the intended
action will fail.
Virus Check Reminder displays the virus check reminder message during system boot up.
System Backup Reminder displays the system back up reminder message during system boot
up.
up.
Password on Boot determines if the system will request a password when starting up.
Power Menu
The Power menu contains the power management settings that help save system power.
Enable ACPI enables or disables ACPI (Advanced Configuration Power Interface) – a power
management standard used by the operating system.
management standard used by the operating system.
Power Saving sets the power saving mode.
Standby Timeout sets the timer for the system to enter Standby mode when it has been idle for
the set time period.
the set time period.
Resume On Modem Ring sets if the system will wake up from Standby mode when an incoming
call occurs.
call occurs.
Resume On Time/Resume Time allows the system to wake up at a specific time.