Manualsbrain.com
  1. Manuels
  2. Marques
  3. Tyan Computer
  4. B2094T15
  5. Manuel D’Utilisation

Tyan Computer B2094T15 Manuel D’Utilisation

Télécharger
Page de 55
45 
http://www.TYAN.com  
6.4  Adding a CD Drive (for test purpose) 
In case you need to use a CD drive with your system, follow this procedure. 
WARNING: You are advised not to make frequent connection and disconnection on the 
IDE connector as this might cause damage to the data cable and connector pins. 
 
CAUTION: Follow the instructions in this section carefully. The DVD or CD drive contains a 
laser device. Do not attempt to open the DVD or CD drive’s  enclosure or remove a DVD or 
CD drive using any procedures other than those contained in this section to avoid the risk of 
exposure to harmful radiation. 
 
With a Secondary Hard Disk Drive Installed 
1.  Remove the cabinet  cover (see section 6.1). 
2.  Unplug the data cable and power cord from the rear of the secondary hard disk drive. Unplug 
the other end of the data cable from the secondary IDE connector on the system board.  
3.  Use the three-heade d power cable that came with your system and connect the single end to 
the previously unplugged power cord (Œ) from step 2. Connect the remaining two ends of the 
power cable, one to the rear of the secondary hard disk drive (•) and the other to the rear of 
the CD  drive (Ž). 
 
4.  Use the three-heade d data cable that came with your system and connect the  single end  to the 
secondary IDE connector  (Œ). Connect the remaining two ends of the data cable, one to the 
rear of the secondary hard disk drive (•) and the other end to the rear of the CD drive (Ž). 
Three-headed power 
cable