Nortel Networks NN44200-700 Manuel D’Utilisation
1002rp server
29
Description
Information
Network interface card
(NIC) LEDs
(NIC) LEDs
Each NIC has two LEDs:
•
The upper LED shows that the network cable is connected.
•
The lower LED blinks to indicate data transfer.
Internal LEDs
Description
Information
MPB16-4 board LED
The five LEDs at the top of the MPB16-4 board are visible through
the grill at the back of the server.
the grill at the back of the server.
•
The four DSP Power On LEDs come on when the CallPilot
drivers are loaded, right before the diagnostic screen starts.
If these LEDs are not on after the system has booted to the
operating system and the diagnostic screen has started, then
one of the following conditions can be present:
drivers are loaded, right before the diagnostic screen starts.
If these LEDs are not on after the system has booted to the
operating system and the diagnostic screen has started, then
one of the following conditions can be present:
— The board is faulty and must be replaced.
— The CallPilot DSP and the NTBus drivers do not function
properly.
— The DSP card to which the LED belongs is faulty.
•
The PCI FPGA Done LED (the farthest from the card bracket)
comes on briefly at startup. If this LED stays on after system
startup, then the MPB16-4 card is faulty and must be replaced.
comes on briefly at startup. If this LED stays on after system
startup, then the MPB16-4 card is faulty and must be replaced.
MPB96 board LEDs
The three red LEDs at the top of the MPB96 board are visible
through the grill at the back of the server.
through the grill at the back of the server.
•
The PCI FPGA Done LED (the closest to the card I/O bracket)
comes on at startup and turns off immediately. This indicates
that the board works properly and was detected correctly by
the system. If this LED stays on after the startup, the card is
defective and must be replaced.
comes on at startup and turns off immediately. This indicates
that the board works properly and was detected correctly by
the system. If this LED stays on after the startup, the card is
defective and must be replaced.
•
The DSP FPGA Done LED comes on at startup and stays on
until the CallPilot drivers are loaded and the diagnostic screen is
displayed. If the LED stays on after the operating system has
until the CallPilot drivers are loaded and the diagnostic screen is
displayed. If the LED stays on after the operating system has
Nortel CallPilot
Troubleshooting Reference Guide
NN44200-700
01.05
Standard
5.0
26 June 2007
Copyright © 2007, Nortel Networks
.