Samsung SWL-2210P Manuel D’Utilisation

 

14 

Windows 98/ME/NT4.0/2000/XP 

 
We will explain the installation method for 

SWL-2210M/P (MiniPCI/PCI Card)

 . 

 

Here are some steps you will perform in establishing your wireless network connection: 
 

1.  Install the Access Point at first. AP is needed in case of Infrastructure network 

mode. 

2.  You should install the Wireless LAN Card (

SWL-2210M/P

).  

3.  Install the software using the Installation CD. 
4.  Install the network protocol(s) required to communicate on your network. Most 

likely you will need the TCP/IP protocol. 

 

Please follow the following steps one by one to install the 

MiniPCI/PCI

 card successfully. 

< Method 1 - Inserting card first > 

1.  Insert the MiniPCI/PCI Card into the slot of your computer.  
2.  Power on your computer and allow Windows 98 to load fully.  
3. “Add New Hardware Wizard” appeared and the system looks for “PCI 

Network Controller”. Press ‘NEXT’ button and check if “Search for the best 
driver for your device(recommended)” is slected and then press ‘NEXT’ 
button . Insert the MagicLAN Installation CD into the CD-ROM drive. 

            

 

 

4.  Mark the “Specify a location” tap and type “E:\Drivers” right below in this 

tap(Where E is the CD-drive of your PC) and then press ‘NEXT’.