Hobart SLA-3 ML-44192 Manuel D’Utilisation

 
F33995 (Rev. A, 6/06) 

Page 10 of 12 

© HOBART 2006 

Cleaning and 
Maintaining 

Maintain the SLA by regularly cleaning the paper dust from 
inside the unit. Clean the SLA exterior surfaces with a cloth and 
warm water/detergent solution. When cleaning, be sure to 
protect the unit from direct water entry. 
 
To clean the SLA: 
 
1.  Dampen a soft cloth with mild detergent and water. 
2.  Wipe the exterior surfaces. 

 

 

Note

 

 

Remove any adhered labels with an alcohol soaked cloth. Do 
not use metal to scrape the labels or adhesive off of the unit. 

 

Troubleshooting 

 
 

 

 

 

 

1.  Out of security labels. Load security 

labels or press escape to continue. 

2.  Verify labels threaded correctly. 
3.  SLA power switch is OFF. 
4.  Check power cord and power source. 
5.  Call local Hobart Office. 
 

 

 

CAUSES/REMIDIES 

 

Power ON indicator is not illuminated and unit will 
not function. 

 

1.  SLA power switch is OFF. 
2.  Check power cord and power source. 
3.  Call local Hobart Office. 

 

 

Power ON indicator is illuminated and will not 
issue label (motor does not run). 

 

 

1.  Call local Hobart Office. 
 

 

Issue label only when manual eject button is 
pressed. 

 

1.  Minimum Unit Price or minimum Total 

Price is set too high in the Security label 
setup and/or apply by PLU is not 
configured correctly in Change Product 
screen in Supervisor. 

2.  Call local Hobart office. 

 

 

Label does not peel off of backing paper. 

 

1.  Verify labels threaded correctly. 
2.  Call local Hobart office.