Lopi Masonry Fireplace Factory Built (Metal) Fireplace Mobile Home Model: Pioneer Bay (Heritage Bay PI) Manuel D’Utilisation
Installation
1 1
Travis Industries
4 0 5 1 2 1 6
9 3 5 0 8 0 5 1
Surround Panel & Circuit Board Installation
•
NOTE: Attach the vent prior to installing the surround panels (& circuit board).
•
The panels are offered in the two sizes shown below:
S i z e
Brass Trim #
Black Trim #
Width
Height
8 x 10 Panels
99300703
99300709
40-1/2"
28-7/8"
10 x 13 Panels
99300704
99300710
44-1/2"
31-7/8"
"L" Bracket
Double-Back Tape
Right Side Trim
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
A
A
A
A
Top
Panel
Panel
NOTE: When installed,
the panels must be 3/8”
off the fireplace face.
the panels must be 3/8”
off the fireplace face.
Top Trim
Panel Trim Construction:
Insert one leg of each "L" bracket
into the top and side trim piece.
Align the trim to form a precise
corner, then tighten the two set
screws with a small standard
screwdriver. Slide the trim over
the panels. Attach a piece of
included double-back tape to the
bottom of each side trim to keep it
from flaring at the bottom.
Insert one leg of each "L" bracket
into the top and side trim piece.
Align the trim to form a precise
corner, then tighten the two set
screws with a small standard
screwdriver. Slide the trim over
the panels. Attach a piece of
included double-back tape to the
bottom of each side trim to keep it
from flaring at the bottom.
Tighten the set screws
from the back side with a
small standard screwdriver
from the back side with a
small standard screwdriver
Install the top panel so the joggle clips slide over the tabs on
top of the side panels and insert.
top of the side panels and insert.
Run the power cord to the side along
the front of the fireplace behind the side
panel (do not route it under the insert).
the front of the fireplace behind the side
panel (do not route it under the insert).
Attach the surround panels to the insert by sliding the slots
on each panel over the tabs on the side of the insert.
on each panel over the tabs on the side of the insert.
Tab
Slot
a
d
e
Remove the circuit board from the rear
hopper support. Disconnect the wiring
harness from the circuit board (see step
“c” below for a detailed view).
hopper support. Disconnect the wiring
harness from the circuit board (see step
“c” below for a detailed view).
Place the right side surround panel near
the insert and attach the wiring harness
to the circuit board.
the insert and attach the wiring harness
to the circuit board.
c
Phillips
Screwdriver
Screwdriver
Attach the circuit board
with the four screws
shipped with the insert.
with the four screws
shipped with the insert.
Phillips
Screwdriver
Screwdriver
Right Side
Surround
Panel
Surround
Panel
Attach the control panel
knob with the bolt (both
included with the
surround panels)
knob with the bolt (both
included with the
surround panels)
b
7/16” Wrench
If using a thermostat,
attach the thermostat
wires at this time.
attach the thermostat
wires at this time.
Back Side of
Circuit Board
Circuit Board
Wiring Harness
(disconnected
in step “a”)
(disconnected
in step “a”)
Pinch these tabs to
remove the wiring
harness.
remove the wiring
harness.