Genie 37026500123 Manuel D’Utilisation

20

The OPEN (UP) and CLOSE (DOWN) door positions
are controlled by making the adjustments on the
panel located on the bottom of the power head. The
adjustments that can be made are: 

Limit controls.

Open 

Travel Limit

Open 

Set Limit

Button

Close 

Travel Limit

Close 

Set Limit

Button

Down Force

Control 

Adjustment

Up Force

Control 

Adjustment

Learn 

Code 

Button

LED

Indicator Light

To 

Garage Door

• Severe injury or death can result if the door 

• Never increase the door closing force above the 

minimum required to move the door. 

• Never adjust force to compensate for a sticking 

or binding door. 

• Perform monthly CONTACT REVERSE TEST as 

described on page 22 and in Section 10.

Limit Controls location
on power head.

1. Press and hold the "Close Travel Limit" button 

until the door is fully closed. 

2. You can quickly press and release the "Close 

Travel Limit"  button to move the door in small 
increments. You can also use the "Open Travel 
Limit"  button to move the door slightly in the 
UP direction. 

3. Door is fully closed when the bottom edge of door

presses firmly onto the ground. 

4. Once the door is in the desired position, press and 

hold the "Close SET Limit"  button for 5 seconds. 
The LED indicator light will blink green once. This 
stores the closed position in memory.

1. Press and hold the "Open Travel Limit" button 

to move the door to its fully opened position. This 
starts the opener moving in the UP direction. 

2. Hold the "Open Travel Limit"  button until the 

door is in the fully opened position that you desire, 
then release this button. 

3. You can quickly press and release the "Open 

Travel Limit"  button to move the door in small 
increments. You can also use the "Close Travel 
Limit"  button to move the door slightly in the 
DOWN direction. 

4. Once the door is in the desired position, press and 

hold the "Open SET Limit"  button for 5 seconds. 
The LED indicator light will blink green twice. This 
stores the opened position in memory.

Carriage Assembly

Chain Connector

Latch 
Movement

Latch 
Movement

Move

 in this dir

ection

Carriage Assembly

Belt Connector

Latch 
Movement

Latch 
Movement

Move

 in this

 direct

ion

Engage Chain/Belt Connector to Carriage.

Operation of the opener without the Chain or Belt
Connector engaged to the Carriage Assembly will
result in damage to rail components including the
rail pulley.

1. Press and hold the "Close Travel Limit" button 

until the chain or belt connector advances and 
engages to the Carriage Assembly (Fig. 6-2). 

Failure to verify the engagement of the belt/chain
connector will result in damage to rail components.

NOTE: Set Close Travel Limit
before setting Open Travel
Limit for unit to operate 
normally.
Unless limits are being reset
do not press set limit buttons.