Hoover cleaner Manuel D’Utilisation

Step 1 Assemble handle

Removing bag door

Pull bag door latch forward and
remove bag door.

Set bag door aside.

With side marked “UP” visible, insert
end into pocket in the bottom of the
bag compartment assembly.

Slide cord protector toward top of
bag assembly and slide through
opening.

With bag compartment in the verti-
cal position, rotate cord protector
(B) on cord so that the arrow is on
the side.

Press protector into the slot (C). Pro-
tector should be pointing downward
when assembly is in the verticle
position.

Pull cord tight.

Press cord into place at each of the
three slots indicated.

Do not plug cleaner in until
assembly is totally complete.

With opening of bag assembly
toward the front, place it down onto
the extension on cleaner base.

Rock handle side to side while
pushing down firmly. Extra push-
ing effort may be required.

Make

sure handle is pushed down com-
pletely.

Push bolt into hole (D) on lower front
of assembly.

Place

nut

in recessed area at

back

of assembly.

Hold nut in place

while tightening bolt securely with a
screwdriver.
Only one nut is needed on this
model. The extra nut is not required
but has been provided for your con-
venience.

1-2

1-3

1-4

1-5

Attaching bag compart-
ment assembly

Remove cardboard protector from
bottom of bag compartment assem-
bly.

1-6

Note:

The

green or white switch

lock

(A) near the ON/OFF switch on

the

back

of the bag compartment

assembly, helps in

assembling

your cleaner.

Assembly can be continued if the
switch lock is missing. However,

do not remove

the switch lock

until assembly is completed.

Attaching cord

Slide cord protector (AA) away
from rectangular end of cord.

Insert large rectangular end of cord
through opening in

back

of bag

compartment.

1-9

1-10

1-8

1-7