Heat & Glo LifeStyle TIARAP-BK Manuel D’Utilisation

Page  34

August 1, 2008

Heat & Glo · Tiara Petite B · 7026-101K

   Open and inspect contents of the blower kit. 

The contents of the kit are listed above. If any of the parts 
are missing or damaged, please contact your dealer for 
replacements. 

NOTE:  Not all parts will be used for this 

install.

TOOLS REQUIRED: Short #2 Philips screwdriver; 11/16" 
wrench.

KIT CONTENTS:  
1 - Blower Mounted in Housing
2 - Speed Control Knob
3 - Pal Nut
4 - Ceramic Snap Disk
5 - Speed Control (Rheostat)
6 - Wire Harness (attached to Blower)
7 - 12 Screws
8 - 12 inch Glass Tape
9 - 1 Zip Tie
10 - Bracket #1 
11 - Snap Disc Bracket 

      Lift off the appliance top and place it on a flat 

surface, with the porcelain side up to prevent damage. 
Remove the back shield by removing the two screws along 
the top of the shield.

  

Place the blower on the fl oor behind the appliance and route 
the ends of the wiring harness through the rubber grommet 
on the underside.

      Holding the blower in place, attach it to the 

appliance with four of the screws provided. 

   Install the snap disc. A snap disc bracket is 

located in the appliance's component bag. Bend the two 
spade teminals on the snap disc from a horizontal to a 
vertical position. Insert the snap disc through the hole in the 
snap disc bracket and attach the two white wires from the 
wiring harness to the snap disc. 

NOTE: The mounting fl ange is on top of the bracket.