HTC WHIT100 Manuel D’Utilisation

18  Getting Started

You need to remove the back cover before you can install the battery and storage card. Also, make sure to 

always turn off the power before installing or replacing the battery.

Make sure your phone is turned off.
Remove the stylus.

Note  You need to temporarily remove the stylus to be 

able to remove or replace the back cover.

Hold the phone securely with the front panel facing 

away from you.
Pull the cover open with your finger from the gap at 

the top of the phone.

Secure the bottom part of the back cover first by aligning the two tabs located on the back cover with 

the two openings on the lower part of the back of the phone.
Press the sides and the top part of the back cover down to lock the cover into place. You will hear a click 

when the back cover is locked in place.

Your phone comes with a rechargeable Lithium-ion battery and is designed to use only manufacturer-

specified original batteries and accessories. Battery performance depends on many factors, including network 

configuration, signal strength, and usage patterns. 
For battery life estimates, see “Specifications” in the Appendix.

Warning!  To reduce risk of fire or burns:

•  Do not attempt to open, disassemble, or service the battery pack.

•  Do not crush, puncture, short external contacts, or dispose of in fire or water.

•  Do not expose to temperatures above 60˚C (140˚F).

•  Replace only with the battery pack designated for this product.

•  Recycle or dispose of used battery as stipulated by local regulations.

Align the battery’s exposed copper contacts with the 

battery connectors at the bottom part of the battery 

compartment.
Insert the contacts side of the battery first and then 

gently push the battery into place.
Replace the back cover.

Lift out the battery from the groove at the upper side of the 

battery compartment.