Razor 13014961 Manuel D’Utilisation

3

 Place the handlebar pad over the 

handlebars and secure tightly with 

the velcro cover.

 Align the holes on the handlebars and the T-bar. Insert handlebar bolts 

into the top of the handlebar and through the T-bar. Install the washers and 

nuts onto the bottom of the handlebar bolts. Tighten securely into place 

using a 10 mm wrench.

q 

Tools Needed: 10 mm wrench

3-1

3-2

3-3

3-4

3-5

3-5

3-3

3-1

3-2

q 

Tools Needed: Two (2) 10 mm wrenches

 Remove the locknut, spring washer and washers (x3)  

from one side of the axle bolt. Insert the axle bolt through 

the rear wheel. Insert the large washer (3-5) onto the axle bolt between the frame and rear wheel and slide the axle 

bolt through the frame. Slide the other large washer and wheel onto the axle bolt. 

Note: Wheels are interchangeable.

Insert the small washer (3-3), spring washer (3-2) and locknut (3-1) onto 

the axle bolt and tighten securely using two (2) 10 mm wrenches.

Make sure the locknut, spring 

washer and small washer are securely 

tightened against the wheel.

3-1 - Locknut
3-2 - Spring washer
3-3 - Washer (small)
3-4 - Axle bolt
Wheel
3-5 - Washer (large)

Rear wheel hardware sequence

Frame

Note: For further assistance, please 

refer to page 5 for parts breakdown.