3com 09-1632-000 Manuel D’Utilisation

C

ONFIGURING

 Y

OUR

 O

FFICE

C

ONNECT

 NETB

UILDER

 10 B

RIDGE

/R

OUTER

d Click Apply.

5 Enable all paths on port 4. 

a In the Dial On Demand ISDN Setup section of the 

navigation frame, click the PATH CONTrol link.

b In the start field, click the arrow and choose 2.1

c In the end field, click the arrow and choose 3.

d In the CONTrol field, click the arrow and choose 

Enabled. 

e Click Apply.

6 If your line speed requirements are different than the 

default (64 Kbps), you need to modify your path baud rate 
configuration. 

a In the Dial On Demand ISDN Setup section of the 

navigation frame, click the PATH BAud link.

b In the start field, click the arrow and choose 3.

c In the BAud field, enter your path baud rate. For 

example, enter:

d Click Apply.

To configure Dynamic Dial, follow these steps:

1 Set the normal bandwidth of the port to the same baud 

rate as you set for the path in the preceding procedure. 

a In the Dial on Demand Dynamic Dial section of the 

navigation frame, click the PORT NORMalBandwidth 
link.

b In the start field, choose 4.

c In the NORMalBandwidth field, enter your port baud 

rate. For example, enter:

d Click Apply.

OC10.book  Page 18  Thursday, May 13, 1999  2:33 PM