Leica FSC Manuel D’Utilisation

19

The connector panel is labeled.

• Connect the left and right stage cables to ter-

minals (17.4) and (17.6).

• Terminal (17.5) on the rear of the stand is con-

nected to terminal (18.1) on the rear side of
the comparison bridge. For this purpose, use
the 25-pin bridge cable.

• The remote control cables of the cold light

sources are connected to terminals (17.9) and
(17.10). When using a cold light source, select
the corresponding terminal.

Stand connector panel

Power supply

Transmitted light condenser lens, right

Transmitted light condenser lens, left

Stage, right

Comparison bridge

Stage, left

Serial interface 1 (PC)

Serial interface 2

Cold light source, right

10 Cold light source, left
11 Serial interface 3 (Smart Move)

Rear side

of the comparison bridge
1

Connection

• If you have not already done so when install-

ing the transmitted light illuminator, connect
the cables for the transmitted light condenser
to terminal (17.2) and/or (17.3).

• The optional Smart Move control panel is con-

nected to the serial interface 3 (17.11).

• The RS232C interface (17.7) is intended for

connecting a PC.

• Finally, connect the comparison macroscope

and the cold light illuminator to the power
supply using the power cable.

1

1

2

3

4

5

6

7

8

9

10

11