National Instruments PXI-1006 User Manual Manuel D’Utilisation
Chapter 1
Installing and Verifying Operation
1-2
ni.com
4.
Install your controller in Slot 1 of your PXI-1006. Install peripheral
cards, if any, in slots 2 through 18.
cards, if any, in slots 2 through 18.
Figure 1-1. Installing Controller and PXI Modules
5.
Set the fan speed selector switch (located on the rear of the chassis) to
either HI for maximum cooling or AUTO to employ the temperature
sensing module that controls the fan speed.
either HI for maximum cooling or AUTO to employ the temperature
sensing module that controls the fan speed.
6.
Power on the chassis. Verify that all fans become operational.
7.
Verify that your controller boots the operating system.
Note
If the chassis does not power on, see Chapter 3,
.
1
PXI-1006 Chassis
2
Peripheral Card
3
Ejector Handle in Down Position
4
PXI Controller
4
1
2
3