TANDBERG Compass Manuel D’Utilisation
TANDBERG COMPASS MXP / UTILITY MXP
10
2.2 Connecting Cables
1. Power cable
Connect the power cable
from the wallplate to the
power supply.
from the wallplate to the
power supply.
Note: The connection of
main electrical supply to
the wallplate is described
in the Installation Sheet.
main electrical supply to
the wallplate is described
in the Installation Sheet.
2. ISDN cables
Connect the ISDN cables
to the ISDN connectors
on the system.
to the ISDN connectors
on the system.
Connect the ISDN cables
to the ISDN sockets (S/T-
interface) provided by the
service provider. Your
main number will be the
number associated with
the socket to which ISDN
cable number 1 is
connected.
to the ISDN sockets (S/T-
interface) provided by the
service provider. Your
main number will be the
number associated with
the socket to which ISDN
cable number 1 is
connected.
North America: The system does
not have a built-in network
terminator. If the wall socket
provides an ISDN U-interface, an
NT1 between the system and the
ISDN line is needed, see
for details.
Note! Write down the
numbers associated with
each of the ISDN lines.
They are needed for
configuring the system
numbers associated with
each of the ISDN lines.
They are needed for
configuring the system
Figure 2-1. Connectors.
3. LAN cable
To use the system on LAN,
connect a LAN cable from the
Ethernet' connector on the system
to the LAN.