Pelco C623M-C Manuel D’Utilisation

C623M-C (3/05)

23

The DX8000 has either 8 or 16 relay outputs, depending on your system’s configuration. Each output is programmed to function as either a 
normally open or normally closed circuit. A signal from a relay output will operate the device connected to the output.

 

To wire a relay output:

1. Insert the blue terminal blocks into the relay sockets on the back panel of the recorder.

2. Connect one wire from the device to one of the relay output terminals 1 through 16.

3. Connect a second wire from the relay device to a GND terminal.

4. Refer to the Operation/Programming manual for information on how to program relay outputs.

Figure 14.  Relay Terminal Installation

IMPORTANT:  The maximum relay power rating is 120 VAC, 0.5 A; 24 VDC, 1 A.

NOTE:  Relay outputs do not have to correspond numerically to alarm inputs. All sensor input and relay output actions can be linked 
through programming.

RELAY

OUTPUT 1

GND