KVH Industries TracVision L2 Manuel D’Utilisation
F.4
Target and Signal Commands
Report Target Location
Function:
reports the target (satellite) location in the baseplate
frame and uses the saved satellite position
frame and uses the saved satellite position
Command:
TGTLOCATION
Argument:
none
Response:
Target Location = E XXX, A XXXX
Report RF Signal Strength
Function:
reports the modified signal strength from the RF power
detector circuit, and applies the RF gain and offset
computed during LNB calibration
detector circuit, and applies the RF gain and offset
computed during LNB calibration
Command:
SIGLEVEL
Argument:
none
Response:
Signal Strength = XXXX
Report IRD Signal Quality
Function:
reports the signal strength from the IRD; it uses the last
received signal quality and initiates a new signal quality
request command from the IRD
received signal quality and initiates a new signal quality
request command from the IRD
Command:
SIGQUALITY
Argument:
none
Response:
Stale Signal Quality = XX
Report IRD Type
Function:
reports the IRD connection type as DSS (DIRECTV),
EchoStar, untested, or none
EchoStar, untested, or none
Command:
IRDTYPE
Argument:
none
Responses:
IRD type has not been tested yet.
IRD type is Echostar.
IRD type is DSS.
IRD type cannot be determined.
IRD type is Echostar.
IRD type is DSS.
IRD type cannot be determined.
F-4
A Guide to TracVision L2
Table F-4
Target and Signal Commands