Marshall electronic V-R171P-HDAV-R171P-HDA Manuel D’Utilisation

4

1.  Unpack the V-R171P-HDA and accompanying power supply. Physically inspect for any damage that may have occurred  

 

 

during shipping. Should there be any damage, immediately contact Marshall Electronics at 800-800-6608. If you are not  

 

 

located within the continental united states call +1 310-333-0606.

2.  Install in your desired location. 
3.  Connect required cables for signal input and output.
4.  Attach battery (Optional) or power connection from power supply to the back of the unit. 
5.  Plug the power supply into the A.C. source
6.  Turn on the V-R171P-HDA by depressing the power switch located on the front of the unit.
 

Refer to Page 4 picture for location of switch settings.

7.  Perform input selections and screen adjustments as detailed in following sections of this document.

Marshall Electronics

12 VDC from

power supply

4 Pin Male XLR

Pin 4 - Pos

Pin 1- Neg

DVI-D In

Component Video

75Ω Terminated

Composite

Video

75Ω Terminated

Pin1 - GND
Pin2 - GND

Pin3 – Y in
Pin4 – C in

S-Video IN

4 Pin Din (Female)

Pin1-Red IN  
Pin2-Grn IN  
Pin3-Blu IN   
Pin4-        
Pin5-      
Pin6-Gnd
Pin7-Gnd
Pin8-Gnd

Pin 9-
Pin10-
Pin11-
Pin12-
Pin13-
Pin14-HSync
Pin15-VSync

SXGA IN

HD-15 Female

Pin1- Green 
Pin2- Red
Pin3-Amber  
Pin4  Ground         
Pin5-  Ground    
Pin6-
Pin7-

in8-
Pin 9-
Pin10-
Pin11-
Pin12-
Pin13-
Pin14-
Pin15-

Tally IN HD-15  Female

5