Avaya P333R-LB Manuel D’Utilisation

Page de 218
Chapter 7
Establishing Switch Access
38
Avaya 
P333R-LB User’s Guide
Establishing a Modem (PPP) Connection with the P330
Overview
Point-to-Point Protocol (PPP) provides a Layer 2 method for transporting multi-
protocol datagrams over modem links. 
Connecting a Modem to the Console Port
A PPP connection with a modem can be established only after the Avaya P330 is 
configured with an IP address and net-mask, and the PPP parameters used in the 
Avaya P330 are compatible with the modem’s PPP parameters. 
1
Connect a terminal to the console port of the Avaya P330 switch as described in 
Connecting a Terminal to the Avaya P330 Serial port.
2
When you are prompted for a Login Name, enter the default name root.
3
When you are prompted for a password, enter the password root. You are 
now in Supervisor Level.
4
At the prompt, type:
set interface ppp <
ip_addr><net-mask> 
with an IP address and netmask to be used by the Avaya P330 to connect via its 
PPP interface.
Note:  
The PPP interface configured with the set interface ppp command 
must be on a different subnet from the stack inband interface.
5
Set the baud rate, ppp authentication, and ppp time out required to match your 
modem. These commands are described in the “Command Line Interface” 
chapter. 
6
At the prompt, type:
set interface ppp enable
The CLI responds with the following: 
Entering the Modem mode within 60 seconds...
Please check that the proprietary modem cable is plugged 
into the console port
7
Use the DB-25 to RJ-45 connector to plug the console cable to the modem’s DB-
25 connector. Plug the other end of the cable RJ-45 connector to the 
Avaya P330 console’s RJ-45 port.
8
The Avaya P330 enters modem mode. 
9
You can now dial into the switch from a remote station, and open a Telnet 
session to the PPP interface IP address.