Mitsubishi Electronics 164 SERIES Manuel D’Utilisation

The Sleep Timer turns the TV off after the length of time 
you set.  To set the TV to turn on at a certain time of 
day, see the 

Setup > Timer menu on page 27.

Press 

SLEEP.

Press 

SLEEP additional times to increase the time in 

30-minute increments up to the maximum of 120 
minutes.
Press 

EXIT or wait five seconds without pressing any 

keys for the message to clear.

Press 

SLEEP to display the on-screen message.

Press 

SLEEP additional times to change the time 

before the TV powers off.  To cancel the Sleep 
Timer, press 

SLEEP repeatedly until OFF is dis-

played.

Connect the camera to the TV using a composite video 
cable and control the slide show or movie through the 
camera.  The display resolution will be standard-defini-
tion (480i).

Refer to the owner’s manual supplied with the 

camera for instructions needed for this setup.
Set the camera’s output signal type to 

NTSC and 

put the camera into playback mode.
With the camera still turned on, connect your digital 

camera’s composite video cable (usually yellow) to 
the TV’s 

Y/VIDEO jack.  To hear audio, connect the 

camera’s audio output cable to the 

AUDIO L jack.

When the 

New Device Found screen displays, 

assign the name 

Camcorder.

Press 

EXIT to close the New Device Found screen.

Highlight the icon for the camera input and press 

ENTER.

If viewing photos, advance through the images 

manually or set the camera to advance automati-
cally.

If viewing photos, control the slideshow from the 

camera.  Advance through the images manually or 
check if the camera can advance automatically.