SCOTT LCT37SHA Manuel D’Utilisation

 Caution: Always use a power cable is properly grounded. Please use the AC

 cords listed below for each area:

   

USA......................UL

   

Canada.................CSA/cUL

   

FCC Information

 This equipment has been tested and found to comply with the limits for a Class

 B digital device, pursuant to part 15 of the FCC Rules. These limits are

 designed to provide reasonable protection against harmful interference in a

 residential installation. This equipment generates, uses, and can radiate radio

 frequency energy, and if not installed and used in accordance with the

 instructions, may cause harmful interference will not occur in a particular

 installation. If this equipment does cause by turning the equipment off and on,

 the user is encouraged to try to correct the interference by one or more of the

 following measures:

 -  Reorient or relocate the receiving antenna.

 -  Increase the separation between the equipment and receiver.

 -  Connect the equipment into an outlet on a circuit different from that to which

   the receiver is connected.

 -  Consult the dealer or an experienced radio / TV technician for help.

FCC Warning

 To assure continued FCC compliance, the user must the provided grounded

 power supply cord and the provided shielded video interface cables to connect

 to this equipment. Also, any unauthorized changes or modifications to this

 equipment would void the user’s authority to operate this device.

HDMI,  the  HDMI  logo  and  High-Definition  Multimedia  Interface  are  trademarks  or

registered trademarks of HDMI Licensing LLC.

Caution (for the product without main power switch)

Since there is not the main power switch used into the product. So

it  is  better  to  detach  the  power  supply  cord  from  the  inlet  of  the

power source while the product is not used for a time. And the main

plug of the product is used as the disconnect device, the disconnect

device shall remain readily operable.