Epson DH200 Manuel D’Utilisation

62

Remote Setup

To configure continuous recording options:

1.

Select a camera.
NOTE: Number of displayed cameras depends 
on model number of your system.

2.

For each camera configure the following:

• USE: Select ON/OFF. If OFF, the selected 

camera(s) will not record.

NOTE: The system will automatically reset 
if you enable/disable any cameras.

• QUALITY: Select LOW, MIDDLE, HIGH, 

SUPER, and ULTRA.

• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.

• AUDIO: Select ON/OFF. Audio capable 

cameras or microphones are required for 
audio recording.

• MOTION: Select ON/OFF. If Motion is set to 

ON, the system will only record from the 
selected camera when motion is detected.

NOTE: Motion Grid and sensitivity must be 
configured in the Motion menu. See “MOTION” 
on page 61.

3. Click APPLY and then OK to save your 

changes and close the window.

To configure alarm settings:
1. Under RECORD SETUP, configure the 

following:

• USE: Select ON/OFF. If OFF, the selected 

camera(s) will not record.

• QUALITY: Select LOW, MIDDLE, HIGH, 

SUPER, and ULTRA.

• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.

• AUDIO: Select ON/OFF. The number of audio 

input channels varies by model.

• INPUT: Select N.O/N.C.

2. Under ALARM SETUP, configure the 

following:

• RECORD TIME: Set from 10~300 seconds (in 

increments of 10 seconds).

• RECORD CAMERA: Select ALL or 1:1. If you 

select ALL, the system will record on all 
channels; if you select 1:1, the system will 
only record for the designated channel

• ALARM BUZZER: Select 

. If ON, the 

system will sound a beep when the external 
alarm is triggered

3.

: Set the type of Alarm Out video 

(external monitor required, not included). 
Select SYSTEM, VIDEO LOSS, MOTION, ALL 
ALARM, or ALARM IN1~8, and then select ON/
OFF

4. Click APPLY and then OK to save your 

settings and close the window.

Figure 35.0 Record options

Figure 36.0 Alarm options