Epson DH200 Manuel D’Utilisation

80

You can enable motion detection and alarm control from the Main Menu. You can also connect 
additional motion sensor devices to the system (i.e. motion sensors, door/window sensors). Use 
a motion detector or sensor to send a signal to the system to begin camera viewing and recording 
on the matching camera channel (when enabled in the Menu).

To connect an external alarm sensor to the system:

1. Connect the Signal Cable to the desired 

 in the alarm block.

2. Connect the Ground cable to the 

 in the alarm block.

3. Open the MAIN MENU and select 

.

4. Select the corresponding alarm channel and select 

.

5. Select 

 (Normally closed) or 

 (normally open) depending on your alarm/sensor setup. 

Make sure the channel is set to 

.

6. Press the 

 button to save your settings.

(Not Included)