Sanyo DSR-M804P Manuel D’Utilisation

Page de 55
English
1
PRECAUTION
Location
For safe operation and satisfactory performance of your
unit, keep the following in mind when selecting a place for 
its installation:
Shield it from direct sunlight and keep it away from sources 
of intense heat.
Avoid dusty or humid places.
Avoid places with insufficient ventilation for proper heat 
dissipation. Do not block the ventilation holes at the top 
and bottom of the unit. Do not place the unit on a carpet 
because this will block the ventilation holes.
Install the unit in a horizontal position only.
Avoid locations subject to strong vibrations.
Avoid moving the unit between cold and hot locations.
Do not place the unit directly on top of a monitor TV, as 
this may cause playback or recording problems.
Avoiding Electrical Shock and Fire
Do not handle the power cord with wet hands.
Do not pull on the power cord when disconnecting it from 
an AC wall outlet. Grasp it by the plug.
If any liquid is spilled on the unit, unplug the power cord 
immediately and have the unit inspected at a factory-
authorised service centre.
Do not place anything directly on top of this unit.
SERVICE
This unit is a precision instruments and if treated with care, 
will provide years of satisfactory performance. However, in 
the event of a problem, the owner is advised not to attempt 
to make repairs or open the cabinet. Servicing should 
always be referred to your dealer or Sanyo Authorized 
Service Centre.
WARNING: TO REDUCE THE RISK OF FIRE OR 
ELECTRIC SHOCK, DO NOT EXPOSE THIS 
APPLIANCE TO RAIN OR OTHER MOISTURE.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
If the power supply cord (AC power cord) of this appliance 
is damaged, it must be replaced. Return to a SANYO 
Authorised Service Centre for replacement of the cord.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type 
recommended by the manufacturer.
Discard used batteries according to the manufacture’s 
instructions.
e00_l8hbc_hd_6.book  Page 1  Wednesday, July 30, 2003  2:34 PM