DirecTV HR10-250 Manuel D’Utilisation

I n s t r u c t i o n s :   T V   P o w e r ,   V o l u m e ,   a n d   T V   I n p u t

2. Enter the search code. Refer to the table below and use the number keys on your 

remote control to enter the appropriate code.  

 After you press the fourth digit of the code, the red light on the end of the remote 
control will flash twice, then remain on.

3. Test the remote control. Point the remote control at the TV or A/V stereo system. 

Press CHAN UP. Did the TV or A/V stereo system turn off? If not, wait two or three 
seconds, then press CHAN UP again. Continue doing this until the TV or A/V receiver 
responds.

When the TV or A/V receiver does turn off, press ENTER to select the current code. 
The red light at the end of the remote control will flash three times to indicate that the 
remote control is properly coded to control your device.

When the red light on the end of the remote control turns off, you have reached the end 
of the available codes.

Unfortunately, due to the great variety of TVs and A/V receivers, some makes and 
models are not compatible with your HD DVR’s remote control. If you reach the end 
of the available codes without finding a code that works with your device, you will 
need to use your TV or A/V receiver’s remote to turn it on and off, and control the 
volume.