Sony SAT-A1 Manuel D’Utilisation

Page de 92
22
Chapter 3: Connecting Your System
Setting Up the RF Antenna
The RF antenna lets you take advantage of the RF (radio frequency) 
feature, which enables the remote control to operate the DSS receiver 
even if the receiver is located in another room or is placed behind a 
cabinet door. In other words, with the RF feature, the remote control 
does not require a direct line-of-sight to the front panel of the DSS 
receiver. 
Note
You must set up the RF antenna only if you plan on taking advantage of the 
RF feature. 
To set up the RF antenna:
1
Connect the RF antenna to the DSS receiver’s RF REMOTE jack.
2
Place the RF antenna at least one foot away from the DSS receiver.
Note
Do not place the RF antenna directly 
on top of the DSS receiver or any 
other metal object.
3
Use the on-screen displays to set up the DSS receiver to accept RF 
transmission (RF ONLY). See “Setting Up the Remote Control” on 
page 69 for det
ails.
The DSS receiver is shipped with IR transmission enabled and RF 
transmission disabled. To use the RF feature, you must first change 
the factory setting (IR ONLY) to the RF setting (RF ONLY) using the 
on-screen displays, as described on page 69.
Note
The operating range of the DSS 
remote control is about 100 ft. This 
may decrease due to ambient radio 
wave conditions, your room’s walls, 
etc.
Optional Setup
‰ The RF antenna can be mounted to a wall using the enclosed 
screws or by using two pieces of double-sided tape (supplied).
Satellite Receiver
RF Antenna
CONTROL S
          IN
OUT
L
R
AUDIO
VIDEO
S VIDEO
CH 3
CH 4
VHF/UHF
VHF(SAT)/UHF
IN
OUT
TEL LINE    
AC IN
WIDE BAND DATA
LOW SPEED DATA
SATELLITE IN
RF REMOTE
AUDIO 3
OUT
(MONO)
AC OUT
L
R