DISH Network 138410 Manuel D’Utilisation

When you receive your system, your remote control and receiver have been set 

to communicate on address 1. However, because UHF signals travel long 

distances and go through walls, a neighbor's UHF Pro remote could control your 

receiver by mistake if they are on the same address. Once all connections have 

been made, to handle this problem, you can change the address on your remote 

control and the receiver as follows:

1. Press 

SYSTEM INFO

 button on the receiver's front panel. The 

screen displays and shows the 

.

Write down the address shown: _____________

2. Press and hold the 

SAT

 button on your remote control for about 

three seconds, until all of the mode buttons light up, and then let 
go of the 

SAT

 button. 

3. Use the 

NUMBER PAD

 buttons to enter any number between 1 

and 16, but not the one you wrote in step 1. 

Write down the number you entered:___________

4. Press the 

POUND

 (#) button. If you entered the address 

correctly, the 

SAT

 mode will flash three times. 

5. Press the 

RECORD

 button. 

: Make sure the

 you see on the

screen is the same as the one you entered in step 3. If it isn't, 

the remote cannot control the receiver.

6. Press the 

SELECT/OK

 button to close the 

screen. 

1. Press and hold the 

SAT

 mode button for three seconds, until all 

of the mode buttons light up, and then let go of the 

SAT

 button. 

2. Press the 

POUND

 (#) button twice. The 

SAT

 mode button will 

flash the same number of times as the address number (for 
example, three flashes means address 3).