DISH Network 138410 Manuel D’Utilisation

This section guides you through the installation of your new satellite receiver, 

which includes the following:

• Connecting to your HDTV set or monitor.
• Connecting to your dish antenna and upgrading the software.
• Ordering your programming.
• Setting up to display in HD.

There are two ways to connect this receiver to display high definition 

programming quality on an HDTV or HD monitor: using the DVI-HDTV/DISH 

DVI connection or the YP

 connections.

: Your new satellite receiver is factory-set to display in the 480p format at 

its HD output connection points.

This video output port is the preferred method of connecting the receiver to a 

DVI-equipped HDTV or HD monitor for best picture quality and simplest 

installation. 

1. Connect a DVI cable between the DVI-HDTV/DISH DVI connection on the 

receiver and the DVI input on your HDTV set or monitor.

2. Connect an RCA A/V cable between the receiver P

 and the HDTV audio inputs that go with the DVI input on your 

TV or monitor.

3. Turn on your receiver and TV.
4. Consult your HDTV User’s Guide, then set your HDTV to display from the 

DVI input. Confirm that you are getting a picture from the receiver.

: In most cases connecting the DVI cable will provide plug-and-play 

control of the monitor’s display resolution and other settings. However, 

your HDTV may require selecting a 480p format to display from the 

receiver during this installation phase. Consult your HDTV User’s Guide.

If your HDTV or HD monitor does not include a DVI input port, you can use 

the YP

 component video connections to provide high definition picture 

quality to your HDTV or HD monitor. Make the connection using a color-coded 

YPbPr cable.

1. Connect video and audio RCA type cables between the receiver RCA A/V 

 and corresponding input connections on the HDTV or monitor.

2. Connect between the YP

 component connections on the receiver and 

the HDTV using component video cables.

3. Power on the TV and receiver using the front panel power button. 
4. Consult your HDTV User’s Guide, then set your HDTV to display from its 

RCA input. Confirm that you are getting a picture from the receiver.