DISH Network SK-1000 Fascicule

The following instructions assume that the TRAV’LER

®

 antenna has found and locked onto satellites 110°, 

119° and 129°. There should be an asterisk next to 110°, 119°, and 129° on the TRAV’LER interface. 

The following instructions are based on a ViP

®

 211 receiver. If your receiver differs from the options shown, 

you may need to consult your receiver manual. The wording and display used in your receiver may 
differ slightly. 

If your receiver is showing a switch type of DPP1K.2, then a check switch test is 

not necessary. In that case, skip to step 7 to complete DISH receiver setup.

If it is of any other type other than DPP1K.2, then check that there are no 

checkmarks by SuperDISH or Alternate, and select Test.

Select option 1,  

Point Dish.

Press Menu on 

your remote.  

Select option 6, 

System Setup.

Select option 1, 

Installation.

Press Cancel 

four times to 

exit the receiver 

menu. 

The receiver 

setup is now 

complete.

Verify that the 

check switch 

resulted in a 

switch type of DPP 

1K.2 and that there 

is a green OK 

status on Satellite 

110, 119 

& 129.

Select 

Winegard and TRAV’LER are registered trademarks of Winegard Company. 

DISH and ViP are registered trademarks of DISH Network L.L.C.