GSI Outdoors PNEG-1521 Manuel D’Utilisation

24

PNEG-1521     Commercial Direct Gear Drive Bin Sweep Auger

C. Attach the ½” Control Rod Clamp to the Control

Rod by inserting the 5/16" x 1-¾” long roll pin
through the Clamp and Control Rod.

D. Fasten the Clutch Handle to the Clamp using two

(2) 5/16" x ¾” Carriage bolts, flat washers, and
Serrated Flange Nuts. Install the nuts so that they
secure the roll pin in place.

E. Check the operation of the Clutch Rod by pulling the handle to engage the clutch and then pushing the

handle to disengage it. The Clutch Control Pipe should slide freely. Lock the Control Pipe into the
disengaged position by tightening the bolt on the Clutch Control Pipe Position Lock that is attached to
the Bin Flange.

Clutch Handle

5/16”Serrated Flange Nut

Flat Washer

5/16” x 1-3/4”

Roll Pin

1/2” Control

  Rod Clamp

Clutch Control Rod

 Clutch Control Rod

 Clutch Control Pipe Guides

 Clutch Control Pipe

Position Lock Bolt

 To Disengage

5/16” x 3/4”

Carriage Bolts

 Clutch Control Arm