Avaya 1600 Series Manuel D’Utilisation

Page de 142
Link Layer Discovery Protocol (LLDP)
Issue 5 April 2010
79
 
attempts occur using the stored 802.1X credentials, without prompting the user for ID and 
password entry.
An IP telephone can support several different 802.1X authentication scenarios, depending on 
the capabilities of the Ethernet data switch to which it is connected. Some switches may 
authenticate only a single device per switch port. This is known as single-supplicant or 
port-based operation. These switches typically send multicast 802.1X packets to authenticating 
devices. 
These switches support the following three scenarios:
Standalone telephone (Telephone Only Authenticates) - When the IP telephone is 
configured for Supplicant Mode (DOT1XSTAT=2), the telephone can support 
authentication from the switch.
Telephone with attached PC (Telephone Only Authenticates) - When the IP telephone 
is configured for Supplicant Mode (DOT1X=2 and DOT1XSTAT=2), the telephone can 
support authentication from the switch. The attached PC in this scenario gains access to 
the network without being authenticated.
Telephone with attached PC (PC Only Authenticates) - When the IP telephone is 
configured for Pass-Through Mode or Pass-Through Mode with Logoff (DOT1X=0 or 1 and 
DOT1XSTAT=0), an attached PC running 802.1X supplicant software can be 
authenticated by the data switch. The telephone in this scenario gains access to the 
network without being authenticated.
Some switches support authentication of multiple devices connected through a single switch 
port. This is known as multi-supplicant or MAC-based operation. These switches typically send 
unicast 802.1X packets to authenticating devices. These switches support the following two 
scenarios:
Standalone telephone (Telephone Only Authenticates) - When the IP telephone is 
configured for Supplicant Mode (DOT1XSTAT=2), the telephone can support 
authentication from the switch. When DOT1X is "0" or "1", the telephone is unable to 
authenticate with the switch.
Telephone and PC Dual Authentication - Both the IP telephone and the connected PC 
can support 802.1X authentication from the switch. The IP telephone may be configured 
for Pass-Through Mode or Pass-Through Mode with Logoff (DOT1X=0 or 1 and 
DOT1XSTAT=1 or 2). The attached PC must be running 802.1X supplicant software. 
Link Layer Discovery Protocol (LLDP)
Release 1.1 1600 Series IP Telephones support IEEE 802.1AB. Link Layer Discovery Protocol 
(LLDP) is an open standards layer 2 protocol IP Telephones use to advertise their identity and 
capabilities and to receive administration from an LLDP server. LAN equipment can use LLDP 
to manage power, administer VLANs, and provide some administration.
The transmission and reception of LLDP is specified in IEEE 802.1AB-2005. The 1600 Series 
IP Telephones use Type-Length-Value (TLV) elements specified in IEEE 802.1AB-2005, TIA