HP (Hewlett-Packard) B.06.X Manuel D’Utilisation
Installing and Configuring PPU Software
Re-installing PPU Software
Chapter 3
33
Re-installing PPU Software
If you re-install HP-UX on a PPU system (for example, installing HP-UX
by either cold-installing or installing from a “golden image”), you need to
perform the following steps to restore your PPU configuration:
by either cold-installing or installing from a “golden image”), you need to
perform the following steps to restore your PPU configuration:
Step 1. Manually save your PPU configuration file by backing up the following
file:
/etc/ppu/ppu_config
Step 2. Install the PPU software (see “Installing PPU Software” on page 26 for
details)
Step 3. Restore your PPU configuration file (from
Step 1
):
/etc/ppu/ppu_config
Step 4. Start the
ppud
daemon (see “Manually Starting the ppud Daemon” on
page 32 for details)
NOTE
An alternative method is to: install the PPU software and configure the
utility meter, thus starting the
utility meter, thus starting the
ppud
daemon.