Panasonic KX-TG1831AL Manuel D’Utilisation
Preparation
13
When charging, the battery icon is shown as
follows.
follows.
When the batteries are fully charged, 5
remains on the display.
remains on the display.
L
The charge indicator lights up when the
handset is placed on the base unit or
charger.
handset is placed on the base unit or
charger.
*1 The pictured model is KX-TG1831.
*2 KX-TG1837 only
Note:
*2 KX-TG1837 only
Note:
L
It is normal for the handset to feel warm
during charging.
during charging.
L
If you want to use the unit immediately,
charge the batteries for at least 15
minutes.
charge the batteries for at least 15
minutes.
L
Clean the charge contacts of the handset,
base unit, and charger with a soft, dry
cloth once a month, otherwise the
batteries may not charge properly. Clean
more often if the unit is exposed to grease,
dust or high humidity.
base unit, and charger with a soft, dry
cloth once a month, otherwise the
batteries may not charge properly. Clean
more often if the unit is exposed to grease,
dust or high humidity.
Battery strength
Panasonic Ni-MH battery performance
(700 mAh)
(700 mAh)
Note:
L
It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L
Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
combination of how often the handset is in
use and how often it is not in use
(standby).
L
Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
over time depending on usage conditions
and ambient temperature.
L
Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L
The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
Turning the power on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Base unit
Charger
Battery icon
Battery strength
5
High
6
Medium
Charge
contact
contact
7
Low
When flashing: Needs
to be charged.
When flashing: Needs
to be charged.
Operation
Operating time
In continuous use
20 hours max.
In continuous
standby mode
standby mode
170 hours max.
Battery icon
Battery strength
TG1831-1837AL(e).book Page 13 Friday, February 3, 2006 2:24 PM