Panasonic KX-TG1840AL Manuel D’Utilisation
Preparation
16
1
Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
firmly and slide it in the direction of the
arrow.
2
Remove the old batteries positive (S)
terminal first and install the new ones.
See page 14 for battery installation.
terminal first and install the new ones.
See page 14 for battery installation.
Turning the power on/off
Power on
Press {ih} for about 1 second.
L
The display will change to the standby
mode.
mode.
Power off
Press {ih} for about 2 seconds.
L
The display will go blank.
Setting the date and time
Important:
L
Confirm that the AC adaptor is connected.
L
Ensure that w is not flashing.
1
Press {j/OK}.
2
Select “Handset Setup”, then press
{>}
{>}
.
3
Select “Time Settings”, then press
{>}
{>}
.
4
Select “Set Date & Time”, then press
{>}
{>}
.
5
Enter the current day, month and year by
selecting 2 digits for each.
Example: 17 May, 2005
Press {1}{7} {0}{5} {0}{5}.
selecting 2 digits for each.
Example: 17 May, 2005
Press {1}{7} {0}{5} {0}{5}.
6
Enter the current hour and minute by
selecting 2 digits for each.
selecting 2 digits for each.
L
You can select “AM”, “PM” or 24-hour
time entry by pressing {*} repeatedly.
time entry by pressing {*} repeatedly.
Example: 3:30 PM
Press {0}{3} {3}{0}, then press {*}
repeatedly until “03:30 PM” is
displayed.
Press {0}{3} {3}{0}, then press {*}
repeatedly until “03:30 PM” is
displayed.
7
Press {j/OK}.
8
Press {ih}.
Note:
L
To correct a digit, press {<} or {>} to
move the cursor, then make the
correction.
move the cursor, then make the
correction.
L
The date and time may be incorrect after a
power failure. In this case, set the date
and time again.
power failure. In this case, set the date
and time again.
TG1840AL(e-e).book Page 16 Tuesday, April 11, 2006 11:02 AM